deleted by creator

Hoffman was sued by Rare Breed Triggers. Hoffman has a give send go for the legal expenses.

https://www.givesendgo.com/hoffmantactical

I second this. Also when the paint inevitably gets scratched, you can just sand and paint again.

I was just talking to my wife about printing an Adderini. I’ll check this out first before I decide. Thanks.

Rails up. Maybe a .4 nozzle would be better. That’s what I use with 100% infill.

This is definitely going on the printer as soon as it’s released!

Looks good but why Sten mags?

deleted by creator

I’ve printed a Glock 19X and two Defiance lowers in Polymaker ASA. I have about two hundred rounds through each and have seen no cracks. I just started printing in Sunlu PA6-CF and honestly it’s easier to print with than the ASA.

Cool. I’ll be looking out for it if you decide to upload.

I’ve been looking for something like this for my 22 build and a unicorn for my wife’s.

Yeah. Mistake on my part.

The FTN is apparently the best but I Form 1’d a Systema Numansky for my AR9 and 300BLK out of ABS. I’m happy with its performance. It requires no extra reinforcement.

My mistake I do have an enclosure but no other mods. I print at 260C hotend temp 95C bed temp.

I’ve had good success with ABS. Deals with heat better than PLA+ and can be printed on stock Ender 3. Edit: Meant to say PLA+ not CF.