The overall length is 26in and the suppressor is 9in long

Yes, everything behind the barrel is identical

9 in, and the overall length is 26in.

It’s should be compatible, but apart from 350 I don’t know if anyone has tried the larger calibers.

I’ve heard from some builders that they had a similar problem with you when trying to get the bolt to hold open. In theory it should be close enough to stay on its own but there are clearly enough variances in individual parts to cause problems. A bolt holdopen is something I’ll look into but if it is too much of a problem, simply removing one of the springs would be a simple solution for the time being.

It uses an FTN 4.5, which works out to 9 inches, then it has an expansion chamber around the ported barrel. That works out to roughly the same length as the unsuppressed TP with a 16in barrel.

It works out to 36 inches in length.

Any AR compaible bolt and barrel should work, but not all of them have been tested. The internals that the AR parts mount to are identical, so barring a caliber that operates outside the standard spec it should be fine.

There are different tolerances for tapping into either metal or plastic, and in this case both 36 and 37 are in tolerance and were used in development. It’s my bad I missed putting the wrong link in the docs :P but either works.

It’s still in progress, but the barrel I’m using to develop it is this one if you want to ensure everything is compatible. I don’t know what variances there are in exact lengrhs so I might just recommend this specific one. https://ar15discounts.com/products/7-5-300-blk-17-black-nitride-barrel/

It should work with any caliber that uses standard AR15 bolts and barrels. x39, 6.5 grendel, 350 legend, 458 socom, etc.

Until approximately now! https://odysee.com/@TheGatalog-PrintableFramesReceivers:9/The-Trash-Panda:a

I’d estimate $400 if you don’t have a lot of standard hardware, to ~$250 if you do.

It can accept any standard shape AR bolt and barrel, I don’t know about 9mm specifically, but if there are mag internals that work you could probably modify them to fit. A new design would probably be more effective though.

It has a 10 round internal magazine