Also, everywhere I read says that when printing PA6-CF, an enclosure is heavily recommended. My SV06 barely reaches high enough nozzle temps as it is. So that is my excuse. Unless I’m wrong? IDK, I’ve had a few issues with the SV06 printing PLA+ already, I doubt its good enough for PA6-CF.
No you’re right, I misread.
Also, everywhere I read says that when printing PA6-CF, an enclosure is heavily recommended. My SV06 barely reaches high enough nozzle temps as it is. So that is my excuse. Unless I’m wrong? IDK, I’ve had a few issues with the SV06 printing PLA+ already, I doubt its good enough for PA6-CF.