• 0 Posts
  • 8 Comments
Joined 2 years ago
cake
Cake day: April 7th, 2024

help-circle
  • Was für ein Blödsinn. Ich zahle doch genau dafür schon Steuern, dass das Sozialsystem mich auffängt, wenn ich keine Arbeit finde bzw. nicht arbeiten kann. Das ist doch meine Gegenleistung fürs Arbeitslosengeld, in welcher Form auch immer. Das ist der Grundsatz vom Land in dem ich lebe, das wir für einander aufkommen und einstehen. Wenn er Leute braucht, die für öffentliche Gelder Schnee schippen, kann er einfach eine öffentliche Stelle ausschreiben - das wäre sogar ein WinWin auf dem Arbeitsmarkt, idealerweise findet damit jemand einen Job aus der Arbeitslosigkeit und ist damit auch aus der Statistik raus. Da muss kein neues Werkzeug her, wir haben genau das was er will schon, nur eben mit weniger denunzierenden Formulierungen.



  • If you have a PEI sheet, try glue stick on the PEI sheet to print. The glue stick acts as a leveraging agent after printing, you can wash it off with warm water - otherwise the flexibles tend to stick too good and ruin the built plate. I use this method on my prusa mini for TPU where I had similar issues. Sticking flexible filament on the textured sheet can be hard, I had success by printing the brim layer in PLA in the past - but that was still on a Makerbot Mk2 which didn’t even have a heated bed.