i have tested something like this for preheating XD https://www.amazon.de/FOHERE-3-Temperaturstufen-Lebensmittelgrad-Silikon-Wärmematte-3-Stunden-Automatik-Abschaltung-Lebensmittelwärmer/dp/B0DDQ1L7WN put pcb on it, max temp, wait 20 min, then use soldering iron and/or hot air
sounds like the tft panel connection is not good anymore? connection of the tft driver to the panel. maybe fpc directly soldered on driver board. device heats up and connection goes bad until fade to black?
the trick: start to count with 11
some day she is gonna be a great doctor!
i am a little bit disappointed that i see no cat butthole in this picture
coool, i still have a psp with such a gps receiver!
the office
i like to say “das leben ist kein ponyschlecken” and “das leben ist kein zuckerhof”.
kevin left the ladder there. he forgot his security access pass at home, therefore he needed a ladder carried on his shoulder when passing security check. this always works: guy with ladder, enters any building - no problem
set up your own openproject docker instance and plan your next event
try BAR - beyond all reason
could it be that the terrifying creeper in the background is Ken Whiteley? The one Raffi is singing with on that album?
cat is build better. cat can stand good.
egg-sackly what op would want
then you have to go with one piece again
in australia even the internet is trying to kill you
maybe dont care. hit all 3 of em. answer is: i have figured out that one of the 3 switches controls the bulb (or not)